济宁休闲

清远附近想过夜电话联系

400-900-8910

Current location: information  >  Technical Q & A > What needs to be done before and after the use of aluminum engraving machine < back to list

What needs to be done before and after the use of aluminum engraving machine

Published on: September 28, 2020 Guangtiandi CNC

The operation of aluminum engraving machine is learned. We can start it simply. It is just a matter of moving your fingers. But you must not know what operation the whole machine has gone through since you press the button. Let us not do a detailed explanation, which is good for the maintenance and service life of your machine.



I. computer


Check and kill the virus regularly, but pay attention not to turn on the anti-virus degree when working, and be careful of interference. Regularly clean the dust of the chassis, pay attention to the heat dissipation of the chassis, and be careful of the industrial control card error caused by too much dust. Regularly defragment the disk and optimize the computer system.


Computer abnormalities can also cause many problems, especially for the computer connected to the aluminum plate engraving machine. During the maintenance of the aluminum plate engraving machine, it was found that the computer abnormality also caused us a lot of unnecessary trouble in repairing and delayed the business of customers.


II. Cleaning up


Cleaning industrial control box regularly, dust is the biggest killer of circuit board. It is very important to prevent the lead screw from sticking to the machine regularly.


After work, the table should be cleaned in time, which provides convenience for the next work of aluminum engraving machine. Clean the guide rail and the material chips beside the guide rail to prevent the machine from jamming during the working process.


3. Oiling


After adding oil, walk back and forth slowly to ensure that the lubricating oil can be evenly added to the guide rail and lead screw. If the machine is not used for a long time, it should be regularly refuelled and empty to ensure the flexibility of the transmission system.


First clean the guide rail and lead screw, and use cloth to remove the grease and material debris on the guide rail and lead screw. Due to the low temperature, you can add oil to the guide rail and lead screw, and it is better to add antifreeze oil. The refueling cycle is twice a month, that is, every two weeks.


4. Temperature


When the machine is not in use, if the room temperature is low, it is better to pour out the water in the water tank to prevent the water tank and water pipe from freezing. Ensure that the operating room temperature, aluminum engraving machine to room temperature, at least the staff will not be very cold. Check the applicable temperature of the refueling standard, at least reach the minimum temperature.


The influence of temperature on the aluminum engraving machine is not great. However, due to the user adding butter to the lead screw and forgetting to clean it in winter, it can not be opened every time when the machine is started. In some workshops, the temperature is very low. Although the oil is added, it still freezes and the machine can not run.


V. cooling water


The coolant can be used under certain conditions. Pay attention to the ambient temperature and be careful of the water tank and water pipe freezing crack caused by the water temperature supercooling. Cooling water is a necessary condition for the normal operation of the spindle motor. If the cooling water is too dirty, it will cause serious damage to the motor, so as to ensure the cleanness of the cooling water and the normal operation of the water pump. Pay attention to the water level, never make the water-cooled spindle motor water shortage, so that the motor heat can not be exported in time.